Home › ENGINE ยท 2AD-FHV › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > INSTALLATION

for Preparation Click here



1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


  1. Check the free length of the compression spring.



      A128853
    1. Using a vernier caliper, measure the free length of the compression spring.

      Minimum length:
      41.5 mm (1.63 in.)

      If the free length is less than the minimum, replace the compression spring.

  1. Connect the front exhaust pipe to the 3 exhaust pipe supports.

  1. Install a new gasket to the front exhaust pipe.

  1. Install the front exhaust pipe and 2 compression springs with the 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



2. INSTALL AIR FUEL RATIO SENSOR


    A126974E02
  1. Using SST, install the air fuel ratio sensor.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
    2. Make sure SST and the wrench are connected in a straight line.



    A206335
  1. Install the wire harness clamp.

  1. Connect the sensor connector.



3. INSTALL TAILPIPE ASSEMBLY


  1. Check the free length of the compression spring.



      A128853
    1. Using a vernier caliper, measure the free length of the compression spring.

      Minimum length:
      38.5 mm (1.52 in.)

      If the free length is less than the minimum, replace the compression spring.

  1. Connect the tailpipe to the 2 exhaust pipe supports.

  1. Install a new gasket to the front exhaust pipe.

  1. Install the tailpipe and 2 compression springs with the 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



4. INSPECT FOR EXHAUST GAS LEAK


  1. Check that there are no exhaust gas leaks from the points (connection areas of the exhaust pipes and installation areas of each sensor) shown in the illustration.


    A206314