Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK CELLULAR PHONE
  1. Check if the other side can hear your voice properly.

    OK:
    Your voice can be heard correctly.



NG
CELLULAR PHONE IS FAULTY
OK


2.CHECK SETTINGS


    E124069E04
  1. Check if the mute switch is set to on.

    OK:
    Mute switch is not set to on.

    Result 
    Result
    Proceed to
    OK (w/ "Bluetooth" Function)
    A
    OK (w/o "Bluetooth" Function)
    B
    NG
    C



B
Go to step 4

C
TURN MUTE SWITCH OFF
A


3.CHECK MICROPHONE (NAVIGATION CHECK MODE)


    E125118E04
  1. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    Voice can be recorded for up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

4.CHECK SETTINGS


    E120069
  1. Enter the "Handsfree Voice Quality Set" mode (Click here).

  1. Check if the "Send Voice Level" is set to "0".

    OK:
    The send voice level has 11 levels (-5 to +5) with increments of 3 db.

  1. Check if the volume is set to the minimum or maximum level.

    HINT:
    When the volume is set to the minimum or maximum level, the sound may be distorted.

    OK:
    Voice level setting is normal.



NG
CHANGE SETTING TO NORMAL
OK


5.CHECK MICROPHONE (NAVIGATION CHECK MODE)


    E125118E04
  1. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    Voice can be recorded for up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)