Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH (for Torx Type)

CRUISE CONTROL MAIN SWITCH (for Torx Type) > INSPECTION

for Preparation Click here



1. INSPECT CRUISE CONTROL MAIN SWITCH


  1. Measure the resistance of the switch.


    E106137E17

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 -3
    +/RES
    216 to 264 Ω
    -/SET
    567 to 693 Ω
    CANCEL
    1,386 to 1,694 Ω
    Cruise control switch ON
    Below 1 Ω
    Cruise control switch OFF
    10 kΩ or higher

    If the result is not as specified, replace the switch.