FRONT SPEED SENSOR > INSTALLATION |
| 1. INSTALL FRONT SPEED SENSOR LH |
![]() |
Set the sensor body into the knuckle, and then install the sensor with the bolt.
Install the sensor clamp and sensor clip as follows.

Simultaneously perform the following: 1) hang the hook part of the sensor clamp (labeled A) on the part of the flexible hose bracket (labeled C); and 2) insert the hook part of the sensor clamp (labeled B) to the part of the flexible hose bracket (labeled D).
Install the sensor clamp to the flexible hose clamp and flexible hose bracket with the bolt (labeled E).
Insert the sensor clip (labeled F) into the hole on the absorber lower bracket.
![]() |
Install the sensor clamp and sensor clip as follows.
Set the sensor clamp (labeled G) on the side member, and then install the bolt (labeled H).
Insert the sensor clip (labeled I) into the hole on the apron.
![]() |
Connect the sensor connector.
| 2. INSTALL FRONT FENDER LINER LH |
![]() |
| 3. INSTALL FRONT WHEEL |
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. CHECK SPEED SENSOR SIGNAL |
w/o VSC:
Check the speed sensor signal (Click here).
w/ VSC:
Check the speed sensor signal (Click here).