Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



2. REMOVE FRONT SEAT ASSEMBLY LH
  1. for Manual Seat:
    Remove the front seat LH (Click here).

  1. for Power Seat:
    Remove the front seat LH (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE LH


    B129699
  1. Using a screwdriver, detach the 10 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE YAW RATE SENSOR BRACKET


  1. Remove the bolt and yaw rate sensor bracket.


    C194672E01



5. REMOVE YAW RATE SENSOR ASSEMBLY (w/ VSC)


    C191844
  1. Disconnect the yaw rate sensor connector.

  1. Remove the 2 bolts and yaw rate sensor.

    NOTICE:
    Do not remove the sensor from the bracket.



6. REMOVE DECELERATION SENSOR (w/o VSC)


    C191841
  1. Disconnect the deceleration sensor connector.

  1. Remove the 2 bolts and deceleration sensor.

    NOTICE:
    Do not remove the sensor from the bracket.