Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL STEERING ANGLE SENSOR


    C128529
  1. Align the locating pins, attach the 6 claws to install the sensor to the spiral cable.



2. INSTALL SPIRAL CABLE SUB-ASSEMBLY (for LHD)
  1. Install the spiral cable onto the turn signal switch.



    C128493E03
  1. Connect all the connectors to the turn signal switch with spiral cable.



3. INSTALL SPIRAL CABLE SUB-ASSEMBLY (for RHD)
  1. Install the spiral cable onto the turn signal switch.



    C127466E01
  1. Connect all the connectors to the turn signal switch with spiral cable.



4. INSTALL STEERING COLUMN COVER (for LHD)


    C128492
  1. Attach the claw to install the upper steering column cover.



    C128491
  1. Attach the 4 claws to install the lower steering column cover.



5. INSTALL STEERING COLUMN COVER (for RHD)


    C127465
  1. Attach the claw to install the steering column cover upper.



    C127464
  1. Attach the 4 claws to install the steering column cover lower.



6. INSTALL STEERING WHEEL ASSEMBLY (for LHD)


    C132123E02
  1. Align the matchmarks and install the steering wheel to the steering column.

  1. Install the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect all the connectors to the spiral cable.



7. REMOVE STEERING WHEEL ASSEMBLY (for RHD)


    C132125E02
  1. Align the matchmarks and install the steering wheel onto the steering column.

  1. Install the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect all the connectors to the spiral cable.



8. INSTALL STEERING PAD ASSEMBLY


B127893E01
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.



    B130245E02
  1. Using a T30 "torx" driver, install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



9. INSPECT STEERING WHEEL CENTER POINT


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


11. INSPECT STEERING PAD ASSEMBLY
  1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.

  1. Check that the horn sounds.



12. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).