DOOR CONTROL RECEIVER (for Short Body) > REMOVAL |
| 1. REMOVE REAR DOOR SCUFF PLATE RH |
![]() |
Using a screwdriver, detach the 8 claws and remove the scuff plate.
| 2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
Remove the rear door opening trim weatherstrip.
| 3. REMOVE REAR FLOOR NO. 1 BOARD |
Remove the rear floor No. 1 board.
| 4. REMOVE DECK BOARD ASSEMBLY |
Remove the deck board.
| 5. REMOVE REAR FLOOR NO. 3 BOARD |
Remove the rear floor No. 3 board.
| 6. REMOVE REAR FLOOR NO. 2 BOARD |
Remove the rear floor No. 2 board.
| 7. REMOVE JACK CARRIER ASSEMBLY |
![]() |
Using a clip remover, remove the 7 clips and remove the jack carrier.
| 8. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE |
![]() |
Remove the 4 screws.
Using a clip remover, detach the 7 clips and remove the plate.
| 9. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Using a clip remover, detach the 6 clips and remove the finish plate.
| 10. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL RH |
![]() |
Using a screwdriver, detach the 6 claws and remove the bezel.
| 11. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER |
![]() |
Using a screwdriver, detach the 4 claws and remove the cover.
| 12. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET |
![]() |
Remove the bolt, 2 washers, collar and bracket.
| 13. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH |
![]() |
Disconnect the rear No. 1 seat belt's floor anchor.
Remove the anchor cover.
Remove the bolt and disconnect the floor anchor.
![]() |
Remove the bolt and 2 screws.
Using a screwdriver, detach the 5 claws.
Using a clip remover, detach the 5 clips and remove the trim board.
Remove the belt hanger.
| 14. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH |
![]() |
Using a clip remover, detach the 7 clips and remove the garnish.
| 15. REMOVE DOOR CONTROL RECEIVER |
![]() |
Disconnect the receiver connector.
Remove the bolt and receiver.