COOLING FAN RELAY > ON-VEHICLE INSPECTION |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE ROOM NO. 2 RELAY BLOCK COVER |
| 3. INSPECT NO. 1 COOLING FAN RELAY (FAN NO. 1) |
![]() |
Remove the relay from the engine room No. 2 relay block.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
Install the relay.
| 4. INSPECT NO. 2 COOLING FAN RELAY (FAN NO. 2) |
![]() |
Remove the relay from the engine room No. 2 relay block.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
| 3 - 4 | Below 1 Ω |
| 3 - 5 | 10 kΩ or higher |
| 3 - 4 | 10 kΩ or higher (when battery voltage is applied to terminals 1 and 2) |
| 3 - 5 | Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
Install the relay.
| 5. INSPECT NO. 3 COOLING FAN RELAY (FAN NO. 3) |
![]() |
Remove the relay from the engine room No. 2 relay block.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
Install the relay.
| 6. INSTALL ENGINE ROOM NO. 2 RELAY BLOCK COVER |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |