Home › ENGINE · 2AD-FTV › COOLING › COOLING FAN RELAY

COOLING FAN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE ROOM NO. 2 RELAY BLOCK COVER


3. INSPECT NO. 1 COOLING FAN RELAY (FAN NO. 1)


B060778E45
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance of the relay.

    Standard Resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.

  1. Install the relay.



4. INSPECT NO. 2 COOLING FAN RELAY (FAN NO. 2)


A087121E01
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance of the relay.

    Standard Resistance:
    Tester Connection
    Specified Condition
    3 - 4
    Below 1 Ω
    3 - 5
    10 kΩ or higher
    3 - 4
    10 kΩ or higher
    (when battery voltage is applied to terminals 1 and 2)
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.

  1. Install the relay.



5. INSPECT NO. 3 COOLING FAN RELAY (FAN NO. 3)


B060778E45
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance of the relay.

    Standard Resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.

  1. Install the relay.



6. INSTALL ENGINE ROOM NO. 2 RELAY BLOCK COVER


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL