CAN COMMUNICATION SYSTEM > Brake Actuator (Skid Control ECU) Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Brake Actuator (Skid Control ECU) Communication Stop Mode | Either condition is met:
|
|

| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistance of the main wire and the branch wire.
| NEXT | |
| 2.CHECK CAN BUS LINE FOR DISCONNECTION (BRAKE ACTUATOR BRANCH WIRE) |
![]() |
Disconnect the A27 brake actuator (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A27-6 (CANH) - A27-5 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
Connect the cable to the negative (-) battery terminal.
![]() |
Disconnect the A27 brake actuator (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A27-2 (GND1) - Body ground | Always | Below 1 Ω |
| A27-24 (GND2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A27-25 (IG1) - Body ground | Ignition switch on (IG) | 11 to 14 V |
|
| ||||
| OK | ||
| ||