POWER DOOR LOCK CONTROL SYSTEM > OPERATION CHECK |
| CHECK ELECTRICAL DOOR LOCK OPERATION |
Check the basic function.
Check that all doors lock when the door control switch (for manual operation) is turned to LOCK and all doors unlock when turned to UNLOCK.
Check that all doors lock when the driver side door lock key cylinder is turned to LOCK using the key.
Check the key lock-in prevention.
Have the key inserted into the ignition key cylinder.
With the driver side door open, check that all doors unlock immediately after the door lock knob for the driver side door is turned to LOCK.
With the driver side door open, check that all doors unlock immediately after the door control switch (for manual operation) is turned to LOCK.
With the driver side door open, turn the driver side door lock knob to LOCK and hold it for 2 seconds or more, and then close the driver side door. Then check that all doors unlock.
| CHECK DOUBLE DOOR LOCKING FUNCTION |
Check that the double locking system is set.
Open all the windows.
Turn the ignition switch on (IG).
Open and close the driver side door, and make sure that all doors, including the back door, are closed securely.
Press the transmitter LOCK switch twice within 5 seconds, and check that the hazard warning lights flash once at this time to indicate that the system has been set.
Try to unlock all doors with the inside handle of the vehicle doors, and check that none of the doors unlock.
Check that the double locking system is canceled.
Press the transmitter UNLOCK switch while the double locking system is set, and check that the hazard warning lights flash twice at this time to indicate that the system is canceled.
Check that the doors can be opened by using both the inside and outside handles.