POWER DOOR LOCK CONTROL SYSTEM > Key Lock-in Prevention Function does not Work Properly |

| 1.READ VALUE USING INTELLIGENT TESTER (UNLOCK WARNING SWITCH) |
Use the Data List to check if the unlock warning switch is functioning properly.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Key Unlock Warning SW | Unlock warning switch signal / ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder | - |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (DRIVER SIDE DOOR COURTESY LIGHT SWITCH) |
Use the Data List to check if the door courtesy light switch is functioning properly.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| D Door Courtesy SW | Driver side door courtesy light switch signal / ON or OFF | ON: Driver side door is open OFF: Driver side door is closed | - |
|
| ||||
| NG | |
| 3.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH |
![]() |
Remove the front door courtesy light switch.
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - Body ground | Not pushed (ON) | Below 1 Ω |
| 1 - Body ground | Pushed (OFF) | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (SWITCH - ECU) |

for LHD:
Disconnect the K8 switch connector.
Disconnect the IA junction block connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| K8-1 - IA-21 (DCTY) | Below 1 Ω |
for RHD:
Disconnect the L4 switch connector.
Disconnect the IC junction block connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| L4-1 - IC-6 (DCTY) | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 5.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Remove the unlock warning switch.
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1- 2 | Not pushed | 10 kΩ or higher |
| 1- 2 | Pushed | Below 1 Ω |
|
| ||||
| OK | |
| 6.CHECK WIRE HARNESS (SWITCH - ECU) |
![]() |
Disconnect the E9 switch connector.
Disconnect the IE junction block connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E9-1 - Body ground | Below 1 Ω |
| E9-1 - IE26 (KSW) | Below 1 Ω |
|
| ||||
| OK | ||
| ||