Home › BODY ELECTRICAL › DOOR LOCK › REAR DOOR LOCK

REAR DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT REAR DOOR WITH MOTOR LOCK ASSEMBLY LH


  1. for LHD, RHD (w/o Double Locking System):



      E123890E01
    1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (L)
      Battery negative (-) → 1 (UL)
      Lock
      Battery positive (+) → 1 (UL)
      Battery negative (-) → 4 (L)
      Unlock

      1. If the result is not as specified, replace the door lock assembly.



    E123914E01
  1. for RHD (w/ Double Locking System):

    1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 2 (L)
      Battery negative (-) → 1 (UL)
      Lock
      Battery positive (+) → 1 (UL)
      Battery negative (-) → 2 (L)
      Unlock

      1. If the result is not as specified, replace the door lock assembly.



2. INSPECT REAR DOOR WITH MOTOR LOCK ASSEMBLY RH


  1. for LHD, RHD (w/o Double Locking System):



      E123891E01
    1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (L)
      Battery negative (-) → 1 (UL)
      Lock
      Battery positive (+) → 1 (UL)
      Battery negative (-) → 4 (L)
      Unlock

      1. If the result is not as specified, replace the door lock assembly.



    E123915E01
  1. for RHD (w/ Double Locking System):

    1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (L)
      Battery negative (-) → 3 (UL)
      Lock
      Battery positive (+) → 3 (UL)
      Battery negative (-) → 4 (L)
      Unlock

      1. If the result is not as specified, replace the door lock assembly.