Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ANTENNA

TIRE PRESSURE WARNING ANTENNA > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT FENDER LINER LH
  1. Partially remove the front fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the speed sensor connector can be disconnected in a later step.



3. REMOVE FRONT FENDER LINER RH

HINT:
Use the same procedures described for the LH side.



4. REMOVE RADIATOR SUPPORT OPENING COVER


B209240
  1. Remove the 9 clips and radiator support opening cover.



5. REMOVE FRONT BUMPER COVER


B208303
  1. Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the RH and LH sides.

  1. Remove the retainer.

    HINT:
    Use the same procedure for the RH and LH sides.



    B209203E01
  1. Put protective tape around the bumper cover.

  1. Using a clip remover, remove the 4 clips.

  1. Remove the 8 screws.



    B208307
  1. Detach the 4 claws and remove the bumper cover.

    HINT:
    The illustration only shows the LH side of the vehicle. The remaining claws are on the RH side.

  1. Disconnect the 2 fog light connectors.



6. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY UPPER


B211609
  1. Remove the 2 bolts and reinforcement.



7. REMOVE HEADLIGHT ASSEMBLY RH


    C128879
  1. Remove the 3 screws and bolt.

  1. Disconnect the connectors and remove the headlight.



8. REMOVE TIRE PRESSURE WARNING ANTENNA FRONT RH
  1. Disconnect the connector.



    C128864
  1. Remove the nut and antenna.



9. REMOVE REAR DOOR SCUFF PLATE LH


    B129711
  1. Using a screwdriver, detach the 8 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



10. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY


11. REMOVE TONNEAU COVER ASSEMBLY


12. REMOVE REAR FLOOR NO. 1 BOARD


13. REMOVE DECK BOARD ASSEMBLY


14. REMOVE REAR FLOOR NO. 3 BOARD


15. REMOVE REAR FLOOR NO. 2 BOARD


16. REMOVE JACK CARRIER ASSEMBLY


B129715
  1. Using a clip remover, remove the 7 clips and remove the jack carrier.



17. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE


B129717
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.



18. REMOVE REAR FLOOR FINISH PLATE


    B129716
  1. Using a clip remover, detach the 6 clips and remove the finish plate.



19. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL LH


    B132537
  1. Using a screwdriver, detach the 6 claws and remove the bezel.

    HINT:
    Tape the screwdriver tip before use.



20. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER


B131613
  1. Using a screwdriver, detach the 4 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



21. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET


    B130163
  1. Remove the bolt, 2 washers, collar and bracket.



22. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH


    B137546
  1. Disconnect the rear No. 1 seat belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.



    B129712
  1. Remove the bolt and 2 screws.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 5 clips and remove the trim board.

  1. Disconnect the power outlet socket connector.

  1. Remove the belt hanger.



23. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH


    B129714
  1. Using a clip remover, detach the 7 clips and remove the garnish.



24. REMOVE TIRE PRESSURE WARNING ANTENNA REAR LH
  1. Disconnect the connector.



    C128876
  1. Remove the bolt and antenna.