TIRE PRESSURE WARNING ECU (w/ Receiver) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD) |
![]() |
Open the glove compartment door.
Detach the claw from the glove compartment door stopper.
While pushing in the sides of the glove compartment door in the direction indicated by the arrows in the illustration, open the door to release it from the 2 stoppers.
![]() |
Open the door as much as possible.
Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.
| 3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER (for RHD) |
Remove the 2 screws.
Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.
| 4. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER |
Disconnect the connector.
![]() |
Remove the bolt and ECU.