DTC B1273 Sliding Roof ECU Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1273 | No communication from sliding roof drive gear for more than 10 seconds | 1. Sliding roof drive gear 2. Main body ECU 3. Wire harness |

| 1.CHECK FOR DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Clear the DTC (Click here).
Check for DTC (Click here).
| DTC No. | Proceed to |
| DTC B1273 is output | A |
| DTC B1273 is not output | B |
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (COMMUNICATION SLIDING ROOF DRIVE GEAR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Read the DATA LIST according to the display on the tester.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Communication Slide Roof | Connection status between sliding roof drive gear sub-assembly (sliding roof control ECU) and main body ECU / OK or STOP | OK: Connection STOP: No connection | - |
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (MAIN BODY ECU - SLIDING ROOF DRIVE GEAR) |
![]() |
Disconnect the R9 gear connector.
Disconnect the E18 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| R9-4 (MPX1) - E18-23 (LIN2) | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK FOR DTC |
Turn the ignition switch on (IG).
Clear the DTC (Click here).
Recheck for DTC (Click here).
|
| ||||
| OK | ||
| ||