CRUISE CONTROL SYSTEM > Clutch Switch Circuit |

| 1.INSPECT CLUTCH SWITCH ASSEMBLY |
![]() |
Remove the clutch switch.
Measure the resistance of the switch.
| Tester Connection | Specified Condition |
| 1 - 2 | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK ECM |

Disconnect the B32 ECM connection.
Turn the ignition switch on (IG).
Measure the voltage of the wire harness side connector.
| Tester Connection | Switch Condition | Specified Condition |
| B32-73 (D) - Body ground | Clutch switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||