Home › BRAKE › BRAKE CONTROL › BRAKE PEDAL LOAD SENSING SWITCH

BRAKE PEDAL LOAD SENSING SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT BRAKE PEDAL LOAD SENSING SWITCH

HINT:
  1. Do not remove the brake pedal load sensing switch from the brake pedal support.
  2. When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support.



  1. Disconnect the brake pedal load sensing switch connector.


    C129075E09



    C129074E03

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Brake pedal depressed
    Approx. 1 kΩ
    1 - 2
    Brake pedal released
    Approx. 213 Ω

    If the result is not as specified, replace the brake pedal support assembly (Click here).