LIGHTING SYSTEM > Footwell Light Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MAIN BODY ECU) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and press the intelligent tester main switch ON.
Select the item below in the ACTIVE TEST and then check the relay operates.
| Item | Test Details | Diagnostic Note |
| Step Light | Foot light ON/OFF | - |
|
| ||||
| NG | |
| 2.INSPECT FUSE (DOME) |
Remove the DOME fuse from the engine room No. 2 relay block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 3.INSPECT FOOT LIGHT |
Remove the foot light.
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, then check that the light comes on.
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (BATTERY - MAIN BODY ECU) |
![]() |
Connect the foot light.
Disconnect the E18 main body ECU connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| E18-2 (FSPT) - Body ground | 10 to 14 V |
|
| ||||
| OK | ||
| ||