TRANSMISSION CONTROL CABLE > ADJUSTMENT |
| 1. ADJUST TRANSAXLE CONTROL CABLE ASSEMBLY |
![]() |
To release the lock (lock condition to lock release condition).
![]() |
Pressing the shift and select lever shaft (*1) and pin (*2), push in pin (*3) and check that the shift and select lever shaft is secured at the 1st-2nd gear selected position (the shaft comes to a stop at the position 8 mm (0.31 in.) below the N position).
Remove the stopper pin, release the lock, and reinsert the stopper pin.
![]() |
Turn the shift lever in the reverse direction without pulling up the slider shaft.
![]() |
While holding the shift lever in the reverse direction, lock the cable length adjustment mechanism of the select cable.
![]() |
Release the pin that fixes the transmission outer lever.
Pull the pin toward the left front side of the vehicle.
![]() |
for new shift lever:
Remove the stopper pin and dispose of it.