TRANSMISSION CONTROL CABLE > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH |
![]() |
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 4 clips and remove the upper panel garnish.
| 3. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH |
![]() |
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 4 clips and remove the upper panel garnish.
| 4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
| 5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Using a screwdriver, detach the 2 clips and 4 claws, and then remove the upper console panel.
| 6. REMOVE SWITCH BASE |
![]() |
Detach the 2 clips and 2 claws.
Disconnect the connectors and remove the switch base.
| 7. REMOVE CONSOLE CUP HOLDER BOX |
![]() |
Remove the 2 screws.
Detach the 2 clips and remove the cup holder box.
| 8. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Using a screwdriver, detach the 4 clips.
Disconnect the connector and remove the upper rear console panel.
| 9. REMOVE CONSOLE REAR END PANEL |
![]() |
Using a screwdriver, detach the 6 claws and remove the console rear end panel.
| 10. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and detach the wire harness clamp.
![]() |
Remove the 2 screws.
Disconnect the connector and remove the rear console box.
| 11. DISCONNECT TRANSAXLE CONTROL CABLE ASSEMBLY |
![]() |
Remove the 2 clips and disconnect the cable ends of the control cable.
![]() |
Using a screwdriver, release the cable locks of the shift cable and select cable.
![]() |
Turn the lock nuts 180° counterclockwise and hold them in that position. Remove the shift cable and select cable while holding them.
Remove the shift cable from the floor shift shift lever assembly while holding the lock nut.
Repeat the step above for the select cable.
| 12. REMOVE TRANSAXLE CONTROL CABLE ASSEMBLY |
![]() |
Removal the 2 clips and washers, and disconnect the top ends of the control cable from the transaxle.
Remove the 2 clips and disconnect the control cable bracket.
![]() |
Remove the 2 bolts from the retainer.
Pull out the control cable from the floor.