Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (for RHD)

BRAKE MASTER CYLINDER (for RHD) > REASSEMBLY

for Preparation Click here


NOTICE:
  1. The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure to tip of the master cylinder points downward when handling the master cylinder.
  2. Make sure foreign matter does not attach to the master cylinder's piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



1. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER


2. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY


3. INSTALL MASTER CYLINDER RESERVOIR GROMMET


    C128541E01
  1. Apply lithium soap base glycol grease to 2 new grommets, and then install them to the master cylinder.



4. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY


5. INSTALL BRAKE MASTER CYLINDER RING PIN