Home › BODY ELECTRICAL › LIGHTING › VANITY LIGHT

VANITY LIGHT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE VANITY LIGHT ASSEMBLY


    B131423
  1. Using a screwdriver, pry out the vanity light assembly.

    HINT:
    Tape the screwdriver tip before use.



    B131425
  1. Detach the 2 claws and vanity light.



3. REMOVE VANITY LIGHT BULB


    B131426
  1. Remove the light bulb from the vanity light.