Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER (REFERENCE)

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Air Conditioner / Utility / Customize.

  5. Select the setting by referring to the table below.

    Air Conditioner 
    Display
    Default
    Contents
    Setting
    Set Temperature Shift
    Normal
    Function to set the temperature shift.
    +2 C/+1 C/Normal/-1 C/-2 C
    Evaporator Control
    Automatic
    Function to set the evaporator control to the automatic position (Automatic) to save power, or to the coldest position (Manual) to dehumidify the air and to prevent the windows from fogging up.
    Automatic/Manual
    Compressor / Air Inlet DEF Operation
    Link
    Function to automatically turn the A/C on when the front defroster button is pressed.
    Link/Normal
    Compressor Mode
    Automatic
    Function to turn the A/C on automatically by pressing the AUTO button when the blower is on and the A/C is off.
    Automatic/Manual
    Air Inlet Mode
    Automatic
    Function to automatically change to recirculation mode when the A/C is turned on.
    Automatic/Manual
    Foot / DEF Auto Mode
    ON
    Function to turn on the airflow from the front and rear footwell register ducts and front defroster automatically when auto mode is on.
    ON/OFF
    Foot / DEF Automatic Blow up Function
    ON
    Function to change the blower level automatically when the front defroster is on.
    ON/OFF