Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (for RHD)

BRAKE MASTER CYLINDER (for RHD) > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK BRAKE FLUID LEVEL WARNING SWITCH
  1. Remove the reservoir filler cap and strainer.

  1. Disconnect the brake fluid level warning switch connector.



    C129064E01
  1. Measure the resistance of the switch.

    HINT:
    There is a float inside the reservoir. Its position can be changed by increasing or decreasing the brake fluid level.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Float up (Switch OFF)
    10 kΩ or higher
    1 - 2
    Float down (Switch ON)
    Below 1 Ω

    If the value is not as specified, replace the brake master cylinder reservoir sub-assembly.

  1. Add brake fluid to the MAX level.