Home › DRIVE LINE › DIFFERENTIAL › ACTIVE TORQUE CONTROL 4WD SYSTEM

DTC    C1280/82    Engine Circuit Malfunction

for Preparation Click here


DESCRIPTION

If a malfunction in the engine control ECU circuit occurs, the 4WD control ECU will output this DTC.

DTC No.
DTC Detection Condition
Trouble Area
C1280/82
  1. When the following continues for 5 seconds or more:
    - Communication with engine control ECU is operating normally, but throttle position sensor is malfunctioning.
  1. Throttle position sensor
  1. Throttle position sensor wire harness and connector
  1. CAN communication system

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG) and check that CAN communication system DTC is not output.
    Result 
    Result
    Proceed to
    CAN communication system DTC is output
    A
    Engine control DTC is output
    B



B
GO TO ENGINE CONTROL SYSTEM
A

GO TO CAN COMMUNICATION SYSTEM