Home › DRIVE LINE › DIFFERENTIAL › ACTIVE TORQUE CONTROL 4WD SYSTEM

ACTIVE TORQUE CONTROL 4WD SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the 4WD control ECU to display 2-digit DTCs by flashing the 4WD indicator light.

WIRING DIAGRAM


C204190E02


INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).

1.CHECK DLC3 (TC VOLTAGE)
H100769E59
  1. Turn the ignition switch on (IG).

  1. Measure the voltage of the DLC3.

    Standard voltage:
    Tester Connection
    Specified Condition
    E16-13 (TC) - E16- 4 (CG)
    10 to 14 V



NG
Go to step 3
OK


2.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
A

REPLACE 4WD CONTROL ECU 

3.CHECK WIRE HARNESS (DLC3 - ECM)
C158618E31
  1. Turn the ignition switch off.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E16-13 (TC) - A12-26 (TC)
    Below 1Ω
    E16-13 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (DLC3 - BODY GROUND)
H100769E56
  1. Measure the resistance of the DLC3.

    Standard resistance:
    Tester Connection
    Specified Condition
    E16-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
A

REPLACE 4WD CONTROL ECU