Home › DRIVE LINE › DIFFERENTIAL › ACTIVE TORQUE CONTROL 4WD SYSTEM

ACTIVE TORQUE CONTROL 4WD SYSTEM > 4WD Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

Refer to "4WD Indicator Light Remains On" (Click here).

WIRING DIAGRAM

Refer to "4WD Indicator Light Remains On" (Click here).

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B

HINT:
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.



B
REPAIR CAN COMMUNICATION SYSTEM
A


2.CHECK COMBINATION METER
  1. Inspect the combination meter (Click here).

    Result:
    The combination meter is normal.



NG
REPLACE COMBINATION METER
OK

REPLACE 4WD CONTROL ECU