LIGHTING SYSTEM > Headlight (HI-BEAM) Circuit |

| 1.CHECK HEADLIGHT |
Check that the headlights (Low) come on when the light control switch is in the HEAD position.
|
| ||||
| OK | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MAIN BODY ECU) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and press the intelligent tester main switch ON.
Select the item below in the ACTIVE TEST and then check the relay operates.
| Item | Test Details | Diagnostic Note |
| Headlight Hi | Turn headlight dimmer switch to HI position: ON / OFF | - |
|
| ||||
| NG | |
| 3.INSPECT FUSE (HEAD LH, HEAD RH) |
Remove the HEAD LH and HEAD RH fuses from the engine room No. 2 relay block.
Measure the resistance of the fuses.
|
| ||||
| OK | |
| 4.INSPECT HEADLIGHT DIMMER RELAY (Marking: DIM) |
![]() |
Remove the headlight dimmer relay from the engine room No. 2 relay block.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω (Battery voltage applied to terminals 1 and 2) |
|
| ||||
| OK | |
| 5.INSPECT HEADLIGHT BULB (HI-BEAM) |
![]() |
Remove the headlight bulbs (Hi-beam).
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, then check that the bulb illuminates.
|
| ||||
| OK | |
| 6.CHECK WIRE HARNESS (MAIN BODY ECU - BATTERY) |
![]() |
Disconnect the E19 main body ECU connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| E19-3 (DIM) - Body ground | Light control switch HEAD | 10 to 14 V |
|
| ||||
| OK | |
| 7.CHECK WIRE HARNESS (HEADLIGHT DIMMER RELAY - BATTERY) |
![]() |
Remove the headlight dimmer relay from the engine room No. 2 relay block.
Measure the voltage of the relay block.
| Tester Connection | Condition | Specified Condition |
| Relay block No. 2 headlight dimmer relay terminal 3 - Body ground | Light control switch HEAD | 10 to 14 V |
|
| ||||
| OK | |
| 8.CHECK WIRE HARNESS (HEADLIGHT DIMMER RELAY AND BODY GROUND - BULB) |

Remove the headlight dimmer relay from the engine room No. 2 relay block.
Disconnect the A19 and A34 headlight (Hi-beam) bulb connectors.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| Relay block No. 2 headlight dimmer relay terminal 5 - A19-2 | Below 1 Ω |
| Relay block No. 2 headlight dimmer relay terminal 5 or A19-2 - Body ground | 10 kΩ or higher |
| Relay block No. 2 headlight dimmer relay terminal 5 - A34-2 | Below 1 Ω |
| Relay block No. 2 headlight dimmer relay terminal 5 or A34-2 - Body ground | 10 kΩ or higher |
| A19-1 - Body ground | Below 1 Ω |
| A34-1 - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 9.INSPECT HEADLIGHT DIMMER SWITCH |
![]() |
Remove the headlight dimmer switch.
Measure the resistance of the switch.
| Tester Connection | Condition | Specified Condition |
| 20 (H) - 12 (EL) | Light control switch HEAD | Below 1 Ω |
| 11 (HU) - 12 (EL) | Headlight dimmer switch HIGH | Below 1 Ω |
| 11 (HU) - 12 (EL) | Headlight dimmer switch LOW | 10 kΩ or higher |
| 17 (HF) - 12 (EL) | Headlight dimmer switch FLASH | Below 1 Ω |
| 17 (HF) - 12 (EL) | Headlight dimmer switch except FLASH | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| 11 (H) - 19 (EL) | Light control switch HEAD | Below 1 Ω |
| 20 (HU) - 19 (EL) | Headlight dimmer switch HIGH | Below 1 Ω |
| 20 (HU) - 19 (EL) | Headlight dimmer switch LOW | 10 kΩ or higher |
| 14 (HF) - 19 (EL) | Headlight dimmer switch FLASH | Below 1 Ω |
| 14 (HF) - 19 (EL) | Headlight dimmer switch except FLASH | 10 kΩ or higher |
|
| ||||
| OK | |
| 10.CHECK WIRE HARNESS (MAIN BODY ECU - HEADLIGHT DIMMER SWITCH) |

Disconnect the E15 headlight dimmer switch connector.
Disconnect the E18 and E20 main body ECU connectors.
Disconnect the IJ instrument panel junction block connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E20-12 (HEAD) - E15-20 (H) | Below 1 Ω |
| E20-12 (HEAD) or E15-20 (H) - Body ground | 10 kΩ or higher |
| E18-22 (HF) - E15-17 (HF) | Below 1 Ω |
| E18-22 (HF) or E15-17 (HF) - Body ground | 10 kΩ or higher |
| IJ-4 (HU) - E15-11 (HU) | Below 1 Ω |
| IJ-4 (HU) or E15-11 (HU) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| E20-12 (HEAD) - E15-11 (H) | Below 1 Ω |
| E20-12 (HEAD) or E15-11 (H) - Body ground | 10 kΩ or higher |
| E18-22 (HF) - E15-14 (HF) | Below 1 Ω |
| E18-22 (HF) or E15-14 (HF) - Body ground | 10 kΩ or higher |
| IJ-4 (HU) - E15-20 (HU) | Below 1 Ω |
| IJ-4 (HU) or E15-20 (HU) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||