COOLING FAN MOTOR > ON-VEHICLE INSPECTION |
| 1. INSPECT NO. 1 COOLING FAN MOTOR |
![]() |
Disconnect the No. 1 fan motor connector.
Connect the battery and an ammeter to the No. 1 fan motor connector as shown the illustration.
Check that the No. 1 fan rotates smoothly, and then check the reading on the ammeter.
| *1 | Component without harness connected (No. 1 Cooling Fan Motor) |
Reconnect the No. 1 fan motor connector.
| 2. INSPECT NO. 2 COOLING FAN MOTOR |
![]() |
Disconnect the No. 2 fan motor connector.
Connect the battery and an ammeter to the No. 2 fan motor connector as shown the illustration.
Check that the No. 2 fan rotates smoothly, and then check the reading on the ammeter.
| *1 | Component without harness connected (No. 2 Cooling Fan Motor) |
Reconnect the No. 2 fan motor connector.