Home › SECURITIES › THEFT DETERRENT › ENGINE HOOD COURTESY SWITCH

ENGINE HOOD COURTESY SWITCH > INSPECTION



1. INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)


B132261E01
  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Lock (OFF)
    10 kΩ or higher
    Unlock (ON)
    Below 1 Ω

    1. If the result is not as specified, replace the hood lock assembly.