METER / GAUGE SYSTEM > Tachometer Malfunction |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TachoMeter Operation) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Perform the Active Test according to the prompts displayed on the tester.
| Tester Display | Tester Part | Diagnostic Note |
| TachoMeter Operation | 0 / 1,000 / 2,000 / 3,000 / 4,000 / 5,000 / 6,000 / 7,000 rpm | Value selected during Active Test is displayed |
|
| ||||
| OK | |
| 2.READ VALUE USING DATA LIST (Engine Rpm) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Read the Data List according to the prompts displayed on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Engine Rpm | Engine speed / Min.: 0 rpm, Max.: 12,750 rpm | Almost same as actual engine speed (When engine is running) | - |
|
| ||||
| OK | ||
| ||