METER / GAUGE SYSTEM > Engine Coolant Temperature Receiver Gauge Malfunction |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (Water Temperature Meter Operation) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Perform the ACTIVE TEST according to the prompts displayed on the tester.
| Tester Display | Test Part | Control Range |
| Water Temperature Meter Operation | LOW / NORMAL / HIGH | Value selected during Active Test is displayed |
|
| ||||
| OK | |
| 2.READ VALUE USING DATA LIST (Coolant Temperature) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and the tester ON.
Read the Data List according to the prompts displayed on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Coolant Temperature | Coolant temperature / Min.: 0°C (32°F), Max.: 127.5°C (261.5°F) | After warming up: 80 to 95°C (176 to 203°F) | If the value is "0°C (32°F)" or "127.5°C (261.5°F)", sensor circuits are open or shorted. |
|
| ||||
| OK | ||
| ||