Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › SHIFT LEVER

SHIFT LEVER > REMOVAL

for Preparation Click here



1. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
  1. Remove the rear console box (Click here).



2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Move the shift lever to N.



    C203403
  1. Disconnect the control cable from the shift lever.



    C127813E02
  1. Pull out the stopper of the transmission control cable.
    Text in Illustration 
    *1
    Stopper
    *2
    Nut

    NOTICE:
    Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

  1. Rotate the nut of the transmission control cable counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

    NOTICE:
    Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.



3. REMOVE FLOOR SHIFT ASSEMBLY



C203384E01

  1. Disconnect the 2 connectors and detach the 2 harness clamps.

  1. Remove the 4 bolts and floor shift.