Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

DTC    C1511/11    Torque Sensor 1 Malfunction

DTC    C1512/11    Torque Sensor 2 Malfunction

DTC    C1513/11    Torque Sensor Deviation Excessive

DTC    C1514/11    Torque Sensor Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

The torque sensor converts the rotation torque input from the steering wheel into electric signals and sends them to the power steering ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1511/11
Torque sensor malfunction
  1. Torque sensor (built into steering column assembly)
  2. Power steering ECU
  3. Connector
C1512/11
C1513/11
C1514/11

WIRING DIAGRAM


C128931E02


INSPECTION PROCEDURE

1.CHECK CONNECTOR CONNECTION CONDITION (TORQUE SENSOR - ECU)
  1. Check the installation condition of the torque sensor connector.

    OK:
    Torque sensor connector is securely connected to the power steering ECU.

    Result 
    Result
    Proceed to
    NG
    A
    OK
    B



B
Go to step 3
A


2.RECONFIRM DTC
  1. Securely connect the torque sensor connector.

  1. Check for DTCs.

    OK:
    DTC is not output.

    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A


3.INSPECT TORQUE SENSOR
  1. Turn the ignition switch on (IG).



    C128930E04
  1. Measure the voltage of the ECU.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    h2-6 (TRQ1) - h2-1 (TRQG)
    Steering wheel not turned (without load)
    2.3 to 2.7 V
    Steering wheel turned to right with vehicle stopped
    2.5 to 4.04 V
    Steering wheel turned to left with vehicle stopped
    0.95 to 2.5 V
    h2-2 (TRQ2) - h2-1 (TRQG)
    Steering wheel not turned (without load)
    2.3 to 2.7 V
    Steering wheel turned to right with vehicle stopped
    0.95 to 2.5 V
    Steering wheel turned to left with vehicle stopped
    2.5 to 4.04 V
    h2-4 (TRQF) - h2-1 (TRQG)
    Always
    3.35 to 3.37 V
    h2-3 (TRQV) - h2-1 (TRQG)
    Always
    8.5 to 10.5 V



NG
REPLACE STEERING COLUMN ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE