Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

DTC    C1552/22    PIG Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

When a problem occurs in the system, the power source relay circuit is shut off to stop the power assist.

DTC No.
DTC Detection Condition
Trouble Area
C1552/22
PIG power source circuit malfunction inside ECU
  1. PIG power source circuit
  2. Power steering ECU

WIRING DIAGRAM


C198252E02


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (PIG POWER SUPPLY)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and press the intelligent tester main switch ON.

  1. Select the item "PIG Power Supply" in the Data List and read the value displayed on the intelligent tester.

    Power steering ECU:

    Tester Display
    Measurement Item/Range
    Normal Condition
    Specified Condition
    PIG Power Supply
    PIG power supply:
    Min.: 0 V
    Max.: 20.1531 V
    Power steering in operation
    10 to 14 V



OK
CHECK INTERMITTENT PROBLEMS
NG


2.CHECK WIRE HARNESS (BATTERY - POWER STEERING ECU)
F100915E02
  1. Disconnect the A2 ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    A2-1 (PIG) - A2-2 (PGND)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE POWER STEERING ECU