REAR BUMPER (for Standard Body) > REMOVAL |
| 1. REMOVE REAR QUARTER PANEL MUDGUARD LH (w/ Rear Fender Mudguard) |
![]() |
w/o Outside Moulding:
Remove the 4 screws and mudguard.
![]() |
w/ Outside Moulding:
Remove the 3 screws and mudguard.
| 2. REMOVE REAR QUARTER PANEL MUDGUARD RH (w/ Rear Fender Mudguard) |
| 3. REMOVE REAR BUMPER COVER |
![]() |
Put protective tape around the bumper cover.
Fully open the back door.
![]() |
w/ Rear Fender Mudguard:
Remove the 3 screws and 7 clips.
![]() |
w/o Rear Fender Mudguard:
Remove the 7 screws and 7 clips.
![]() |
Pull the rear bumper cover to detach the 12 claws.
![]() |
Open the back door one notch and following the order in the illustration, pull down the left side of the cover, then pull down the right side of the cover and remove it by pulling it out from between the back door and body.
Disconnect the rear fog light connector.
w/ Licence Plate Light:
Disconnect the licence plate light connector.
| 4. REMOVE REAR BUMPER ENERGY ABSORBER |
![]() |
Remove the Rear bumper energy absorber.
| 5. REMOVE REAR NO. 1 BUMPER REINFORCEMENT |
![]() |
Remove the 6 bolts and rear No. 1 reinforcement.
| 6. REMOVE REAR BUMPER ARM SUPPORT REINFORCEMENT LH |
![]() |
Remove the 3 bolts and rear bumper arm support reinforcement.
| 7. REMOVE REAR BUMPER ARM SUPPORT REINFORCEMENT RH |
| 8. REMOVE REAR BUMPER SIDE SUPPORT LH |
![]() |
Remove the screw.
Detach the 2 claws and remove the rear bumper side support.
| 9. REMOVE REAR BUMPER SIDE SUPPORT RH |
| 10. REMOVE REAR UPPER BUMPER RETAINER LH |
![]() |
Remove the 2 screws.
Detach the 2 claws and remove the rear upper bumper retainer.
| 11. REMOVE REAR UPPER BUMPER RETAINER RH |