REAR BUMPER (for Standard Body) > DISASSEMBLY |
| Item | Temperature |
| Rear Bumper Protector | 20 to 30°C (68 to 86°F) |
| rear bumper cover | 20 to 30°C (68 to 86°F) |
| 1. REMOVE LICENSE PLATE LIGHT ASSEMBLY (w/ License Plate Light) |
Disconnect the connector.
![]() |
Using a screwdriver, remove the light as shown in the illustration.
| 2. REMOVE REAR UPPER BUMPER COVER LH (w/o License Plate Light) |
![]() |
Detach the 2 claws and remove the rear upper bumper cover.
| 3. REMOVE REAR UPPER BUMPER COVER RH (w/o License Plate Light) |
| 4. REMOVE REAR BUMPER PROTECTOR (w/o License Plate Light) |
![]() |
Put protective tape around the rear bumper protector.
Using a moulding remover, detach the double-sided tape and remove the rear bumper protector.
| 5. REMOVE REAR FOG LIGHT ASSEMBLY LH |
![]() |
Remove the 3 bolts and rear fog light.
| 6. REMOVE REAR FOG LIGHT ASSEMBLY RH |
| 7. REMOVE REAR BUMPER SIDE MOULDING SUB-ASSEMBLY LH (w/ Outside Moulding) |
![]() |
Remove the screw.
Detach the 5 clips and remove the side moulding.
| 8. REMOVE REAR BUMPER SIDE MOULDING SUB-ASSEMBLY RH (w/ Outside Moulding) |