DOWNHILL ASSIST CONTROL SWITCH > INSPECTION |
| 1. CHECK DOWNHILL ASSIST CONTROL SWITCH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 4 | Not pushed | 10 kΩ or higher |
| 1 - 4 | Pushed in | Below 25 Ω |
Check the illumination operation.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 3 Battery negative (-) → Terminal 2 | Bulb illuminates |