Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Ignition Switch Circuit


DESCRIPTION

When the ignition switch is on (IG), the battery positive voltage is applied to terminal IG of the theft warning ECU. When the battery positive voltage is applied to terminal IG of the ECU while the theft deterrent system is operating, the warning siren stops. Furthermore, the power supplied from terminal IG of the ECU is used as the power for the door courtesy light switch and position switch, etc.

WIRING DIAGRAM


B133212E01


INSPECTION PROCEDURE

1.CHECK VEHICLE TYPE
Vehicle type: 
Vehicle Type
Proceed to
w/ Entry and start system
A
w/o Entry and start system
B


B
Go to step 3
A


2.CHECK BASIC FUNCTION (ENTRY AND START SYSTEM)
  1. Check that the basic function of the entry and start system (for starting) operates normally (Click here).

    OK:
    Basic function of entry and start system (for starting) operates normally.



NG
Go to ENTRY AND START SYSTEM
OK


3.INSPECT FUSE (ECU-IG1, AM1, AM2-2)
  1. Remove the ECU-IG1 and AM1*1 fuses from the instrument panel junction block.

  1. Remove the AM2-2*2 fuse from the engine room No. 1 relay block.

  1. Measure the resistance of the fuses.

    HINT:
    *1: w/ Entry and start system
    *2: w/o Entry and start system

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
4


4.CHECK WIRE HARNESS (THEFT WARNING ECU - IG POWER SOURCE AND BODY GROUND)
B132525E02
  1. Disconnect the E83 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E83-16 (E) - Body ground
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E83-9 (IG) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE THEFT WARNING ECU