ENTRY AND START SYSTEM > Room Oscillator does not Recognize Key |

| 1.CHECK DOOR CONTROL TRANSMITTER (OPERATION) |
Temporarily replace the door control transmitter with a new or normally functioning one (Click here).
Check that the wireless door lock and unlock functions operate normally.
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (INDOOR ELECTRICAL KEY OSCILLATOR) |
Select the Active Test, use the intelligent tester to generate a control command, and then check that the indoor electrical key oscillator (front, rear) operates.
| Item | Test Details | Diagnostic Note |
| Fr-Seat Inside Transmitter | Indoor electrical key oscillator (front) ON / OFF | - |
| Inside Trunk/Backdoor Transmitter | Indoor electrical key oscillator (rear) ON / OFF | - |
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (INDOOR ELECTRICAL KEY OSCILLATOR - CERTIFICATION ECU) |
![]() |
Disconnect the L14*1 and K23*2 oscillator connectors.
Disconnect the E63 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| L14-1 (CLG3) - E63-11 (CLG5) | Below 1 Ω |
| L14-3 (CLGB) - E63-12 (CG5B) | |
| L14-1 (CLG3) or E63-11 (CLG5) - Body ground | 10 kΩ or higher |
| L14-3 (CLGB) or E63-12 (CG5B) - Body ground |
| Tester Connection | Specified Condition |
| K23-1 (CLG6) - E63-15 (CLG7) | Below 1 Ω |
| K23-3 (CLGB) - E63-16 (CG7B) | |
| K23-1 (CLG6) or E63-15 (CLG7) - Body ground | 10 kΩ or higher |
| K23-3 (CLGB) or E63-16 (CG7B) - Body ground |
|
| ||||
| OK | |
| 4.CHECK INDOOR ELECTRICAL KEY OSCILLATOR (OPERATION) |
Carry the key into the vehicle.
Temporarily replace the indoor electrical key oscillator with a new or normally functioning one.
Depress the clutch pedal*1 (brake pedal*2) and check that the engine switch indicator illuminates in green.
|
| ||||
| NG | ||
| ||