ENTRY AND START SYSTEM > Entry Functions do not Operate at All |

| 1.CHECK KEY CANCEL FUNCTION |
Check that the key cancel function has been set (Click here).
|
| ||||
| NG | |
| 2.CHECK WIRE HARNESS (CERTIFICATION ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the E63 ECU connector.
Measure the resistance and voltage of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E63-17 (E) - Body ground | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E63-18 (IG) - Body ground | Ignition switch on (IG) | 10 to 14 V |
| Ignition switch off | Below 1 V | |
| E63-1 (+B1) - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | ||
| ||