ENTRY AND START SYSTEM > Back Door Entry Lock Function does not Operate |

| 1.CHECK FOR DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
By following the tester screen display, check whether any DTCs are output.
|
| ||||
| OK | |
| 2.CHECK MANUAL DOOR UNLOCK OPERATION |
Check that all the doors unlock when the door control switch (for manual operation) is turned to UNLOCK.
|
| ||||
| OK | |
| 3.CHECK WIRELESS DOOR LOCK CONTROL OPERATION |
Check that the wireless door lock and unlock functions operate normally (Click here).
|
| ||||
| OK | |
| 4.READ VALUE USING INTELLIGENT TESTER (LOCK SWITCH) |
Check the Data List for proper functioning of the door lock switch.
| Item | Measurement Item / Range (Display) | Normal Condition | Diagnostic Note |
| Tr/B-Door Lock SW | Back door lock switch / ON or OFF | ON: Back door lock switch pushed OFF: Back door lock switch is not pushed | - |
|
| ||||
| OK | |
| 5.CHECK ECU AGGREGATION BOX (OPERATION) |
Temporarily replace the ECU aggregation box (certification ECU) with a new or normally functioning one.
Check that the entry lock and unlock functions operate normally (Click here).
|
| ||||
| OK | ||
| ||
| 6.INSPECT BACK DOOR OUTSIDE HANDLE |
![]() |
Disconnect the back door outside handle connector.
Measure the resistance between the terminal when the lock switch is operated.
| Tester C0nnection | Condition | Specified Condition |
| 1 - 3 | Switch released | 10 kΩ or higher |
| Switch pressed in | Below 1 Ω |
|
| ||||
| OK | ||
| ||