PROPELLER SHAFT ASSEMBLY > INSTALLATION |
| 1. TEMPORARILY INSTALL PROPELLER SHAFT WITH CENTER BEARING SHAFT ASSEMBLY |
![]() |
Align the matchmarks of the transfer and propeller shaft.
Temporarily install the propeller shaft with center bearing with the 4 nuts and 4 washers.
![]() |
Align the matchmarks of the differential carrier and propeller shaft.
Temporarily install the propeller shaft with center bearing with the 4 nuts and 4 washers.
![]() |
Temporarily install the center support bearing and center support bearing washer with the 2 bolts.
| 2. TIGHTEN PROPELLER SHAFT WITH CENTER BEARING SHAFT ASSEMBLY |
Tighten the 4 nuts of the propeller shaft and transfer to the torque specification.
Tighten the 4 nuts of the propeller shaft and differential carrier to the torque specification.
Check that the center line of the center support bearing housing is perpendicular to the axis of the propeller shaft.
Tighten the 2 bolts of the center support bearing to the torque specification.
| 3. INSPECT JOINT ANGLE |
Before the angle measurement, stabilize each part by performing procedures like those described below.
Rotate the propeller shaft several times by hand.
Set the jack to the differential, and raise and lower the differential.
Using SST and a straightedge, measure the angle of the transfer flange (angle D) and the angle of the intermediate shaft (angle A).

Subtract the measured angle of the intermediate shaft (angle A) from the measured angle of the transfer flange (angle D) to obtain the No. 1 joint angle.
| Measurement Position | Engine | Transmission | No. 1 Joint Angle |
| D - A | 2AD-FTV 2AD-FHV | M/T | 2°27' +/-60' |
| 2AD-FHV | A/T | 2°31' +/-60' |
Using SST, measure the angle of the intermediate shaft (angle A) and the angle of the propeller shaft (angle B).

Subtract the measured angle of the propeller shaft (angle B) from the measured angle of the intermediate shaft (angle A) to obtain the No. 2 joint angle.
| Measurement Position | Engine | Transmission | No. 2 Joint Angle |
| A - B | 2AD-FTV 2AD-FHV | M/T | 1°29' +/-1°30' |
| 2AD-FHV | A/T | 1°59' +/-1°30' |
Using SST, measure the angle of the propeller shaft (angle B) and the angle of the rear differential (angle C).

Subtract the measured angle of the propeller shaft (angle B) from the measured angle of the rear differential (angle C) to obtain the No. 3 joint angle.
| Measurement Position | Engine | Transmission | No. 3 Joint Angle |
| B - C | 2AD-FTV 2AD-FHV | M/T | 2°10' +/-60' |
| 2AD-FHV | A/T | 2°06' +/-60' |