REAR DRIVE SHAFT ASSEMBLY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN DIFFERENTIAL OIL |
![]() |
Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket, and drain the oil.
Install a new gasket to the rear differential drain plug.
Using a 10 mm socket hexagon wrench, install the rear differential drain plug and gasket.
| 3. REMOVE REAR WHEEL |
| 4. REMOVE TAILPIPE ASSEMBLY |
Remove the tailpipe for 2AD-FTV .
Remove the tailpipe for 2AD-FHV .
| 5. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Remove the front pipe for 2AD-FTV .
Remove the front pipe for 2AD-FHV .
| 6. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
![]() |
Remove the 2 bolts and 2 adjusting washers, and disconnect the propeller with center bearing shaft.
![]() |
Place matchmarks on the differential carrier and propeller shaft.
Remove the 4 nuts and 4 washers, and disconnect the propeller shaft and differential carrier.
![]() |
Place matchmarks on the transfer and propeller shaft.
Remove the 4 nuts and 4 washers, and disconnect the propeller shaft from the transfer.
| 7. REMOVE REAR AXLE SHAFT NUT |
![]() |
Using SST and hammer, unstake the staked part of the nut.
While applying the brake, remove the lock axle hub nut.
| 8. DISCONNECT DIFFERENTIAL CARRIER ASSEMBLY |
![]() |
Support the rear differential carrier with a transmission jack or equivalent.
Fix the nuts in place and remove the 2 bolts A and bolt B.
![]() |
Slowly lower the jack and then tilt the rear differential carrier as shown in the illustration.
![]() |
Set the tip of the tire lever to the position on the rear drive shaft inboard joint shown in the illustration. Then, using the ribbed part of the rear differential carrier as a fulcrum, disconnect the left and right rear drive shafts.
| 9. DISCONNECT REAR SPEED SENSOR LH |
Disconnect the speed sensor .
| 10. REMOVE REAR DRIVE SHAFT ASSEMBLY LH |
![]() |
Put matchmarks on the drive shaft and the axle hub.
Using a plastic-faced hammer, separate the drive shaft from the axle hub.