REAR DRIVE SHAFT ASSEMBLY > REASSEMBLY |
| 1. INSTALL REAR DRIVE SHAFT DUST COVER LH |
![]() |
Using SST and a press, press in a new drive shaft dust cover.
| 2. INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH |
Install a new hole snap ring.
| 3. INSTALL REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY LH |
Wrap the spline of the outboard joint shaft with vinyl tape to prevent the boots from being damaged.
Install new parts to the outboard joint shaft in the following order.
Inboard joint boot clamp
No. 2 inboard joint boot clamp
Inboard joint boot
Place the beveled side of the tripod axial spline toward the outboard joint.
Align the matchmarks placed before removal.
![]() |
Using a brass bar and hammer, tap the tripod joint onto the drive shaft.
Pack the inboard joint shaft and boot with grease from the boot kit.
![]() |
Using a snap ring expander, install a new shaft snap ring.
Align the matchmarks, and install the inboard joint to the outboard joint shaft.
| 4. INSTALL REAR AXLE INBOARD JOINT BOOT |
Install the inboard joint boot to the inboard joint.
| 5. INSTALL REAR DRIVE SHAFT INBOARD JOINT BOOT NO. 2 CLAMP LH |
![]() |
Using needle-nose pliers, install the No. 2 inboard joint boot clamp, as shown in the illustration.
| 6. INSTALL REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP LH |
![]() |
Using a screwdriver, install the inboard joint boot clamp, as shown in the illustration.
| 7. INSPECT REAR DRIVE SHAFT |
![]() |
Check that there is no severe play in the radial direction of the outboard joint.
Check that the inboard joint slides smoothly in the thrust direction.
Check that there is no severe play in the radial direction of the inboard joint.
![]() |
Check the boots for damage.