DIFFERENTIAL CARRIER OIL SEAL > REMOVAL |
| 1. DRAIN DIFFERENTIAL OIL |
![]() |
Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket, and drain the oil.
Install a new gasket to the rear differential drain plug.
Using a 10 mm socket hexagon wrench, install the rear differential drain plug and gasket.
| 2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
Remove the propeller shaft (Click here).
| 3. REMOVE ELECTROMAGNETIC COUPLING |
![]() |
Install a dial gauge so that it is perpendicular to the inner side of the transmission coupling.
Using SST, rotate the transmission coupling assembly forward and backward and measure the vertical runout.
Install a dial gauge perpendicularly onto the transmission coupling assembly, as shown in the illustration.
Using SST, rotate the transmission coupling assembly forward and backward and measure the lateral runout.
| 4. REMOVE 4WD LINEAR SOLENOID |
![]() |
Using a snap ring expander, remove the snap ring.
![]() |
Remove the solenoid from the yoke.
Remove the O-ring from the solenoid.
| 5. REMOVE YOKE |
![]() |
Using a 5 mm socket hexagon wrench, remove the 3 bolts and yoke from the differential carrier.
| 6. REMOVE TRANSMISSION COUPLING CONICAL SPRING WASHER |
![]() |
Remove the spring washer from the differential carrier.
| 7. REMOVE TRANSMISSION COUPLING SHIM |
![]() |
Remove the shim from the differential carrier.
| 8. REMOVE DIAPHRAGM OIL SEAL |
![]() |
Using SST, remove the oil seal from the rear differential carrier.