FRONT SHOCK ABSORBER WITH COIL SPRING > INSTALLATION |
| 1. INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING LH |
![]() |
Install the front shock absorber with coil spring (upper side) with the 3 nuts.
![]() |
Install the front shock absorber with coil spring to the steering knuckle with the 2 bolts and 2 nuts.
| 2. INSTALL FRONT STABILIZER LINK ASSEMBLY LH |
Install the link with the 2 nuts.
| 3. CONNECT FRONT SPEED SENSOR LH |
![]() |
Set the sensor body into the knuckle, and then install the sensor with the bolt.
Install the sensor clamp and sensor clip as follows.

Simultaneously perform the following: 1) hang the hook part of the sensor clamp (labeled A) on the part of the flexible hose bracket (labeled C); and 2) insert the hook part of the sensor clamp (labeled B) to the part of the flexible hose bracket (labeled D).
Install the sensor clamp to the flexible hose clamp and flexible hose bracket with the bolt (labeled E).
Insert the sensor clip (labeled F) into the hole on the absorber lower bracket.
![]() |
Install the sensor clamp and sensor clip as follows.
Set the sensor clamp (labeled G) on the side member, and then install the bolt (labeled H).
Insert the sensor clip (labeled I) into the hole on the apron.
![]() |
Connect the sensor connector.
| 4. INSTALL FRONT WHEEL |
| 5. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
Inspect and adjust the front wheel alignment (Click here).