Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER WITH COIL SPRING

FRONT SHOCK ABSORBER WITH COIL SPRING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE FRONT SPEED SENSOR LH


    C127964E05
  1. Disconnect the sensor connector.



    C193404E01
  1. Remove the sensor clip (labeled A), bolt (labeled B) and sensor clamp (labeled C).



  1. Remove the sensor clip (labeled D), bolt (labeled E) and sensor clamp (labeled F).


    C127962E01



    C127961E01
  1. Remove the bolt and sensor body from the knuckle.

    NOTICE:
    Keep the sensor tip and sensor installation hole free from foreign matter.



3. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


    C127528
  1. Remove the 2 nuts and stabilizer link.



4. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING LH


    C127533
  1. Remove the 2 bolts and 2 nuts, and disconnect the shock absorber from the steering knuckle.

    HINT:
    While fixing the nuts in place, loosen and remove the bolts.



    C127542
  1. Remove the 3 nuts and shock absorber with coil spring.