REAR COIL SPRING > INSTALLATION |
| 1. INSTALL REAR COIL SPRING INSULATOR LOWER LH |
Install the insulator lower to the suspension No. 2 arm.
| 2. REMOVE REAR COIL SPRING LH |
Install the coil spring to the suspension No. 2 arm.
| 3. INSTALL REAR COIL SPRING INSULATOR UPPER LH |
Align the stopper part of the insulator upper with the coil spring tip, and install the insulator upper.
| 4. TEMPORARILY INSTALL REAR SUSPENSION NO. 2 ARM ASSEMBLY LH |
![]() |
Slowly raise the suspension No. 2 arm with a jack, and connect the suspension No. 2 arm to the axle carrier.
Install the bolt and nut.
| 5. INSTALL REAR STABILIZER LINK ASSEMBLY LH |
![]() |
Install the stabilizer link with the 2 nuts.
| 6. CONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY |
Connect the cable to the backing plate and parking brake shoe lever.
Pass the cable through the backing plate, and then connect the cable to the lever.
Install the cable to the backing plate with the bolt.

Install the clamp and clamp bolt (labeled F) to the trailing arm.
Install the clamp and clamp bolt (labeled E) to the rear suspension crossmember.
Install the clamp and clamp bolt (labeled D) to the crossmember.
Install the clamp and clamp bolt (labeled C) to the body.
Install the casing cap and casing cap bolt (labeled B) to the body.
Install the cable clamp (labeled A) to the body.
| 7. INSTALL SKID CONTROL SENSOR WIRE (for 2WD) |
![]() |
Connect the skid control sensor wire connector (labeled A) to the skid control sensor.
Install the sensor clamp (labeled B) with the bolt (labeled C).
![]() |
Install the sensor clamps (labeled D) with the 2 nuts (labeled E).
Install the sensor clamp (labeled F) with the bolt (labeled G).
![]() |
Insert the connector and grommet into the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.
![]() |
Connect the skid control sensor wire connector.
| 8. INSTALL REAR SPEED SENSOR LH (for 4WD) |
![]() |
Install the sensor (labeled A) with the bolt (labeled B).
Install the sensor clamp (labeled C) with the nut (labeled D).
![]() |
Install the sensor clamps (labeled E) with the 2 nuts (labeled F).
Install the sensor clamp (labeled G) with the bolt (labeled H).
![]() |
Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it from the inside of the vehicle to the outside of the vehicle. Then fix it in place so that it is not tilted.
![]() |
Connect the speed sensor connector.
| 9. INSTALL REAR WHEEL |
| 10. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 11. TIGHTEN REAR SUSPENSION NO. 2 ARM ASSEMBLY LH |
Install the nut and 2 bolts.
| 12. CHECK SPEED SENSOR SIGNAL |
w/o VSC:
Check the speed sensor signal (Click here).
w/ VSC:
Check the speed sensor signal (Click here).
| 13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |
Inspect and adjust the rear wheel alignment (Click here).